Genset Controls

Generator control panel

Complete control panels for diesel gensets. We build these at the shop, so a panel can be made to your set's rating and specification instead of forcing a stock unit to fit.

A new control panel backplate with DIN rail terminals, a contactor and a circuit breaker

What to send us

The number stamped on the old part is the quickest route. If it has worn off, the engine or genset model and serial number usually gets us there. Photos help more than descriptions.

We cross-check whatever you send against the OEM catalogue and confirm the match with you before anything ships.

About this range

The panel is the enclosure and everything in it: the controller, the AVR, the metering, the breaker or contactor, the battery charger and the relay wiring that ties them together. AMF panels add the mains sensing and the changeover that let a set start on its own.

Most panel work that reaches us is one item inside it rather than the whole thing. A controller that has gone blank, an AVR that is over-exciting, a relay card that no longer picks up, a charger that is not holding the battery. Replacing the failed item is usually the right answer, and we would rather identify it with you than sell a panel.

For a complete panel, tell us the set rating in kVA, the alternator make, whether it is single or three phase, and whether it needs to run in AMF or manual. Panels are built to specification here.

Products in this category

1 listed

Open one for its specification and the part numbers it covers. We stock more than we list, so send us the number even if yours isn’t here. You can also look a number up in the part number index.